Your net cost for a heat pump in Tucson is the contractor's written installation quote minus up to $720 from Tucson Electric Power (TEP) and up to $2,000 from the federal 25C tax credit. For a 2,000-square-foot home, that is up to $2,720 in combined savings if you qualify for both at the full amounts. A 4-ton quote is a reasonable starting point to discuss, but the tonnage should be backed by a load calculation for your house.
What will a heat pump installation cost you after rebates?
The price on your quote depends on the equipment you choose, your ductwork, and the size the load calculation calls for. The savings, however, follow a simple formula you can apply to any quote:
- Start with the total on the written quote.
- Subtract the TEP instant rebate, up to $720.
- Subtract the federal credit, up to $2,000, when you file your taxes.
The TEP rebate comes off at the time of purchase. The federal credit arrives later, as a reduction in the tax you owe, and it is nonrefundable. If your tax bill is lower than the credit, you cannot collect the difference as a refund.
Ask each contractor to list equipment price, labor and any duct work on separate lines. That makes it easy to compare quotes and to see which amounts the rebate and credit apply to.
How big a heat pump does a 2,000-square-foot Tucson home need?
The U.S. Department of Energy says equipment should be sized from calculated building design loads rather than a simple Btu-per-square-foot rule. That means a 4-ton system is a number to test, not assume.
The DOE points to ACCA Manual J for calculating loads and Manual S for selecting compatible equipment, as described in its right-size guidance. Manual J accounts for insulation, windows, shading, infiltration, ducts and the number of occupants.
Two homes of the same size can land on different tonnages. A house with shaded west windows and tight ducts will differ from one with older glass and leaky ducts.
A heat pump also has to cover heating, not just cooling. The DOE's air-source heat pump sizing guide says to size for both estimated loads. It also says that when you replace a whole-house system, the heat pump's capacity at design conditions should not exceed, and may be smaller than, your existing heating equipment.
Ask any contractor quoting 4 tons to show you the Manual J results behind the number.
What TEP rebate can you get for a heat pump?
TEP's Efficient Home Program offers an instant rebate of up to $720 for a high-efficiency heat-pump quality installation. The program applies to purchasing and installing a new certified air conditioner or heat pump.
The program requires a participating Efficient Home Program contractor. If you hire someone outside the program, you can lose the rebate, so confirm participation before you sign. Our page on TEP rebates for Tucson homeowners explains how the program fits into a replacement project.
Your old equipment matters too. TEP's HVAC incentive application limits eligibility to operable existing systems with a nameplate SEER rating of 10.0 or less. Check the nameplate on your outdoor unit before you plan around the rebate.
What ratings does TEP require?
TEP's HVAC incentive application lists different minimums for split and packaged heat pumps. New equipment must meet or exceed the listed minimum ENERGY STAR requirements.
| Heat pump type | Minimum SEER | Minimum EER | Minimum HSPF |
|---|---|---|---|
| Split system | 14.5 | 12.0 | 8.2 |
| Packaged system | 14.0 | 11.0 | 8.0 |
Compare these numbers against the specification sheet for the exact outdoor and indoor combination in your quote. Ratings can differ between matched sets of the same brand line.
How does the federal 25C credit work for heat pumps?
The IRS says the Energy Efficient Home Improvement Credit carries a separate annual $2,000 limit for heat pumps, heat-pump water heaters, biomass stoves and biomass boilers. That limit is apart from the $1,200 limit for other eligible improvements, so your total annual 25C credit can reach $3,200.
In practice, a heat pump alone can earn up to $2,000. Pairing it with other eligible work in the same year, such as qualifying improvements covered by the $1,200 limit, is what can lift the total toward $3,200.
What efficiency does the federal credit require?
There is no single SEER2 and HSPF2 pair to memorize. The IRS says an electric or natural-gas heat pump must meet or exceed the highest applicable CEE efficiency tier in effect at the beginning of the installation year.
IRS Publication 5967 adds that the heat pump must meet the CEE highest efficiency tier, excluding any advanced tier.
Ask your contractor to confirm in writing that the exact model you are buying meets the CEE highest tier for the year it is installed. Keep that confirmation with your invoice.
How should you plan the credit before the year ends?
The credit is tied to the year of installation, and the efficiency tier is the one in effect at the start of that year. As of November 2026, that means equipment installed in 2026 is measured against the tier that applied on January 1, 2026.
If you are weighing a replacement, these steps keep the paperwork straight:
- Collect at least two written quotes that include the Manual J load results.
- Confirm the contractor participates in TEP's Efficient Home Program.
- Photograph the nameplate on your existing outdoor unit to document the SEER rating.
- Get the model numbers and efficiency documentation in writing.
- Keep the final invoice showing the installation date.
Federal eligibility also depends on your own tax situation and on documentation requirements, so run the numbers by a tax professional before you count on the full $2,000. If your current system is failing, our overview of AC replacement in Tucson shows what a replacement visit involves. If it is a heat pump you already own, see heat pump repair before deciding to replace it.
Not sure where to start? Call (520) 303-1924 or send a request and we will connect you with a licensed local heating and air company. Tucson Air Conditioning Repair is a free referral service and does not perform the work itself.



